PRESET

Introduction:

The VJX16-4 has a bank of 16 user presets for each of the sections or sub-sections of the table. These presets can be used or saved at any moment, using the 4*4 matrix.

Organization of the presets:

For each of the 9 following sections or sub-sections, you have 16 presets:

• Keyer section
• Fx sub-section
• Motion sub-section
• Crop sub-section
• RGB sub-section
• BCS sub-section
• Transition sub-section
• Audio Type sub-section
• Audio Link sub-section

All of the parameters which allow the configuration of each the sections or sub-sections are saved in the presets. However, the In. Track parameter of the Keyer section and the Track parameter of the Transition section are not saved.

Organization of presets on the VJX16-4

You can also save or recall all the parameters of one track on the 9 preset banks. Recalling a preset by track will reload all 9 preset banks. For example: if you recall preset n° 6 of a track, this action will subsequently recall Keyer preset n° 6, Fx preset n° 6 and so on.

You also have 16 presets available to configure your tracks which contain the parameters of the following section or sub-sections:

• Keyer Section
• Fx sub-section
• Motion sub-section
• Crop sub-section
• RGB sub-section
• BCS sub-section
• Blend sub-section
• Bkg. Alpha sub-section
• Negative sub-section
• B & W sub-section

Recalling the presets:

To recall the presets and to assign all of the parameters to the section or sub-section of the selected tracks, keep the button of the section or sub-section you wish to reload, pressed down, then press one of the 16 buttons of the 4*4 matrix, to reload the parameters.

To reload a preset of track, press down on the SELECT button of the track that you wish to reload and press one of the 16 buttons of the 4*4 matrix to reload the parameters.

Saving presets:

From the first time you switch the VJX16-4 on, all the Presets are initialized with the Factory Presets. You can then modify and save each of these presets.

• To save one section or sub-section:
  • Select the section or sub-section that you wish to save.
  • Press the Preset button. The LCD screen will then display the option to save the section or sub-section in one of the 16 Presets:

Screen showing the saving option for an RGB Preset

• Now press the button on the 4*4 matrix corresponding to the preset which you wish to use. The former preset is replaced by the new parameters. The LCD screen indicates that it has been saved successfully.

Screen display confirming that an RGB Preset has been saved

• To save a track:
  • Press the Preset button, then the Select button of track which you wish to save. The screen will show you the option to save all of the parameters of the track in one of the 16 Presets:

Screen showing the saving option for Track 1

• Then press the button on the 4*4 matrix which corresponds to the preset which you want to use. The old preset is replaced by the new parameters. The LCD screen indicates that it has been saved successfully.

Screen display confirming that Track 1 has been saved

Tip: All Presets are saved in the memory of the table even after it has been switched off.

Resetting the presets:

You can reset all of the Presets of the table with the Factory Presets. In this case, the presets you may have saved previously are lost and replaced with the factory presets.

Refer to the MASTER MENU chapter for a description of how to reset the presets.